Passer til 1911 og 2011 våpen.
For kaliber 9mm, 38 Super & Supercomp og 40 S&W.
Overlegen kvalitet og vår anbefalte ekstraktor.
Holder spennet lenge og trenger sjeldent etterjustering.
Fra produsent:
The steel available to us today is of much higher quality than what was available in 1911 when the 1911 pistol was first produced.
Improvements to the entire manufacturing process include better alloys, more controlled furnaces, vacuum heat treat, better tooling, and finite element analysis-all of which EGW uses in production.
EGW-specific Improvements to the original 1911 Extractor:
We found that the extractor rides up the relief groove on the ammunition casing with each round fired: this dulls the hook from constantly banging the case, over time tension is lost, leading to a jammed case which adversely affects accuracy.
We fixed all 3 of these problems by reducing the distance from the bolt face to the extractor hook.
We found that most hook designs are cut straight at a right angle. We machined ours at an acute angle so that there is more surface area for the hook to bite into the case. Right angles are a weak point on other extractors so we put radii on both sides of ours to increase strength. The hook is machined with a special cutter that leaves a nice clean radius in the inside corner where most extractors fail.
We found that the back section is normally thin and we machined ours to have a fully solid back further increasing the strength. We checked slides from 5 manufactures during development and they were all different in the back radius where the extractor is blended. In machining, we left the rear face slightly longer allowing space so that a Gunsmith can custom blend the extractor to your slide for a perfect fit.
Lastly our extractor is vacuum heat treated yielding great spring properties and the capability to maintain tension for 70,000+ rounds.
