En automatisk tennhettefyller.
I motsettning til tradisjonelle løsninger som Dillon RF-100 med vibratorplate har Primer-Pro roterende disk 20 kanaler for sortering av hettene.
Primer-Pro bruker en optisk sensor for å fylle røret automatisk med 100 tennhetter og stopper av seg selv når 100 er nådd.
Den vil også kunne stoppe matingen av hetter om det skulle oppstå feil med matingen.
Grunnet litt variasjoner i hetter, så kan fyllingen av rørene ligge på 98-100 hetter.
Dette er ikke et produkt som nødvendig vis er plug-n-play.
Det er relativt store forskjeller på tennheter både med tanke på størrelse, coating og hvor mye de skitner til.
Så det vil i mange tilfeller kreves litt tilpassninger og justeringer for å få maskinen til å gå 100%.
Noen tennhetter legger igjen mer smuss enn andre og vil kreve noe mer renhold.
Variasjonene på hetter gir også noe variasjoner i fyllehastighet.
En av de tingene vi ser mest som årsak til at maskinen stopper er at primere ikke sklir fort/lett nok i maskinen.
Instruksjon under med å smøre glideflatene er det som normalt løser det.
Fungerer kun for small primer (både pistol og rifle).
Følger med:
PRIMER-PRO Maskin
Strømforsyning med av/på bryter og 2m ledning
1 stk Magnet for tennhette rør (flere kan kjøpes separat)
Følger ikke med:
Tennhetterør (Kan bruke vanlige tennhetterør med standard diameter)
Link til video som viser smøring/polering med f.eks dashbord shine/pledge etc.
Tips & Tricks
Fra DAA:
The PRIMER-PRO by Double-Alpha is an innovative patent-pending design which departs from the traditional vibratory bowl solution used by all other automated primer tube machines. The PRIMER-PRO uses a collator type solution where the primers are allowed to exit the bowl through 20 precisely formed channels, ONLY if they are orientated in the correct direction (Anvil side up). If they are Anvil down, they will not pass through the channel, and rather slide back into the bowl as their channel reaches the top of the rotation, to enter again later, correctly oriented.
This rejection-type design makes it practically impossible for a primer to enter the output channel if incorrectly orientated, making this device extremely reliable. During development, we ran many successful tests in which 100 tubes were filled (10,000 primers fed) without a single up-side-down primer!
As the primers slide down the covered output-chute, they pass through an optical sensor which counts them and stops the collator once 100 primers have been counted into the primer-tube. The electronic processor board also monitors the sensor and is programed to stop the collator if, for whatever reason, primers hang-up on the exit hole and stack up along the ramp. The collator will be stopped before the primers stack all the way up and jam the collator. In such a case, the LED will flash quickly to indicate there is a problem. Once cleared, pressing the start button again will allow the collator to run and the count will continue from where it was stopped. Or alternatively, a long press on the button will start the count a new.
One of the most innovative design solutions of the PRIMER-PRO is the Output Actuator Arm, which is activated by a lever system off the Timing Disk at the bottom of the Collator Assembly. This Output Actuator Arm slides the primers from the bottom of the ramp slide, moving them over to above the output hole, holding them there for a split second to ensure they are static, horizontal and stable, and then retracting to allow the primer to fall cleanly down into the awaiting primer tube. This dynamic solution for the exit hole greatly reduces the chance of primers hanging up while exiting into the tube, a problem common with other automated primer fillers.
Omtaler
Det er ingen omtaler ennå.